Noraxon Ultium Motion Quick Start Manual page 3

Ultium Motion Quick Start Guide
Insert the USB cable (CBL2) into the USB connector on the
back of the Ultium Receiver (880).
Insert the opposite end of the USB cable into an available
USB port on the computer.
Step 2
Insert the Motion Sensors (870) into the Sensor Charger
(873).
Note: Sensor power button & LED must face the front of
the Charger, i.e., toward the charger LEDs.
Step 3
Connect the Receiver to the Sensor Charger (873) using
the ports on either side of the Receiver.
Step 4
Insert the power supply (PSU1) barrel connector into the
associated receptacle on the back of the Ultium Receiver
to charge sensors.
Note: Sensor LED will show solid orange while charging
and turn off when fully charged.
(Rev A)
3