Connecting The Data Cables (And Wlan Cards) - Nokia M1112 User Manual

4.3

Connecting the data cables (and WLAN cards)

WARNING
Do not connect the gateway's power cord yet!
Note
If you are using WLAN cards, note that the installation procedure described
below only covers the physical installation of the WLAN cards.
Before you can use your gateway's wireless feature, you must first install Nokia
C110/C111 WLAN card software on your computer. The software and
installation guide are delivered with the optional Nokia C110/C111 WLAN card.
Connect the data cables
1.
2.
3.
4.
16 (40) © Nokia Networks Oy
Nokia Proprietary and Confidential
All manuals and user guides at all-guides.com
Nokia M/MW Gateways M1112, M1122, MW1112, MW1122, MW1324, MW1352
Connect the 8-pin Ethernet cable between the computer's Ethernet card and
the gateway's Ethernet connector located in the gateway's back panel.
Steps 2 and 3 are for MW1324 only.
If you use a splitter with your MW1324, connect an additional DSL/HPNA
cable (RJ-12) between the HPNA connector of your MW1324 and a phone
wall socket after the splitter.
If you use a microfilter before each phone, you do not need to install the
additional DSL/HPNA cable. In such a case, leave the HPNA connector
unconnected. (The HPNA signal uses the same cable as ADSL, so no
additional cabling is needed.)
Connect each PC in your home network to your home phoneline network
(without microfilters). Your PC's must be equipped with HPNA network
adapters.
Connect the 6-pin DSL cable between the gateway's DSL connector and
your DSL phone wall socket.
DN01154358
Issue 1-0 en