Advertisement
Electrical connection
The electrical connection is made at a 230 V ~ 50 Hz socket outlet with earthing fuse protection at
least 10 A.
Commissioning
Place the unit on a level, stable surface with a temperature not higher than 40
rizontally so that it may operate correctly. Then connect it to the power supply.
Safety precautions
Using the machine, you should follow the following basic measures to avoid electric shock, injuries, or
damages caused by fire.
To ensure personal safety, please turn off the main power switch after you have completed
your work. Always unplug the power cord when the machine is not in use for a longer time.
You must use approved and recommended original parts. Otherwise this will lead to con-
sequences and the warranty will void.
Machine failures must only be repaired by the manufacturer or an authorized service partner.
Do not repair the product on your own.
This product is grounded by a three-wire plug. It must always be plugged into a fitting socket
that is grounded as well. The plug must never be changed in any kind or used with a socket
without grounding.
When the soldering iron or soldering station is switched on, the temperature is likely to reach
400
℃
. Do not use the station near flammable gases or objects. The emitted heat is very high
and can cause serious burns. Never do touch the hot pipe and avoid exposition of heat to the
human body.
Please ensure that the environment is safe for work when turning on the soldering iron. Never
leave the station unattended when it is switched on.
When the soldering iron is in work, never install a new nozzle while it is working or still hot.
The heat pipe and nozzle must have time to cool down after being switched off. After the parts
had time to cool down, another nozzle may be installed.
If you want to box the station after use, let it cool down first.
Do not use the soldering iron outside. Never try to clear the residual flux of the working sur-
face with the soldering iron. This will cause serious damage to the iron.
The machine will produce smoke during operation. Please be sure that the piece where it is
operated is properly ventilated.
Warning!
If the supply cord is damaged, it has to be replaced with a new electricity cable; this work is
only allowed to be done by a qualified technician.
Warning:
This tool must be placed on its stand when it is not in use.
Be careful when using the appliance in places where there are combustible materials; do not
apply the station to the same place for a long time.
Be aware that heat may be conducted to combustible materials that are out of sight. Never
leave the device unattended when it is switched on.
This device is not intended for use by people (including children) with reduced physical, sens -
ory or mental capabilities or lack of experience or knowledge. Unless they are supervised or
have been instructed regarding the use of the device by a person responsible for their safety,
they are not allowed to work with the station.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61538
℃
. Position the unit ho
Page 4
02
2021-1
-
Advertisement
