Advertisement
Introduction
Thank you for purchasing this quality product. To minimize the risk of injury we urge that our cli-
ents take some basic safety precautions when using this device. Please read the operation in -
structions carefully and make sure you have understood its content.
Keep these operation instructions safe.
General safety instructions
Attention:
The device may only be used with a residual current circuit breaker with a tripping
rated current of up to 30 mA (according to VDE 0100 Part 702 and 738).
This device is not intended to be used by people (including children) with limited physical, sensory or
mental abilities or lack of experience and/or knowledge, unless they are supervised or instructed by a
person responsible for their safety on how to use this device. Children should be supervised to ensure
that they do not play with the device.
During the operation of the device, the temperature of the soldering iron is between 100 ℃ and
480 ℃. This could result in injury or damage to equipment in the work area if the soldering station is
not handled carefully.
Please observe the following principles when working with the device:
After opening the delivery package, please check that each part of the device is in a good
condition and that there is no visible damage caused during transit. If there is obvious
damage, please do not put the device into operation and contact your dealer immediately.
Switch off the device and disconnect the mains plug if you move the device.
Avoid exposing parts of the device to increased mechanical stress (impact, shock, etc.).
Attention:
Perform a visual inspection of the device before every use. Do not use the device if safety
devices are damaged or worn. Never disable safety devices.
Only use the device for the purpose specified in these instructions for use.
You are responsible for the safety in the work area.
If the cable or plug is damaged due to external influences, the cable must under no circum -
stances not be repaired, but must be replaced with a new one by a qualified technician.
The voltage of 230 V AC specified on the type label of the device must correspond to the ex-
isting mains voltage.
Never lift, transport or attach the device to the power cord.
Make sure that the electrical plug connections are protected from flood and moisture.
Disconnect the mains plug before carrying out any work on the device.
Avoid exposing the device to a direct jet of water.
The operator is responsible for compliance with local safety and installation regulations (ask a
qualified electrician if necessary).
If the device should fail, repair work may only be carried out by a qualified electrician.
Warning:
Do Read all safety instructions and notes. Failure to follow the safety precautions
and instructions may result in electric shock, fire and/or serious injury. Keep all safety information and
instructions for future reference.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61538
Page 3
02
2021-1
Advertisement
