Advertisement
On/off switch (Fig. 7)
To turn the machine on, press the "I" button on
the on/off switch (16). Before starting the cutting
procedure, wait until the cutting wheel has
reached its max. speed and the cooling water
pump (13) has started to provide the cutting
wheel with water.
To turn the machine off, press the button "0" on
the on/off switch (16).
Cutting at a 90° angle (Fig. 8/9)
1. Unscrew the star grip screw (27).
2. Adjust the angular stop (5) at a 90° angle and re-tighten the star grip screw (27).
3. Re-tighten the screws (28) to fix the angular stop (5).
4. Move the machine head (29) via the handle (9) to the other side. Lay the tile against the rail
stop (6) at the angular stop (5).
5. Turn the tile cutter on.
Caution:
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Always wait until the cooling water has reached
the cutting wheel (2)! Move the machine head (29)
slowly and smoothly through the tile (9)
via the handle. After cutting, turn
the tile cutter off.
Item 61285
Page 7
03
2021-1
Advertisement
