Advertisement
Trouble shooting
Problem
Motor does not run.
The machine is slowing
down during the cutting
process.
The cutting line is inac-
curate.
Motor is overheating.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Possible cause
Malfunctioning power switch
Malfunctioning or damaged
power cable
Malfunctioning or damaged
switch relay, blown out motor
Blown fuse
You are applying too much
pressure to the work piece.
Dirty cutting mechanism
Worn cutting disc
Rip fence adjusted inexactly
Work table dirty
Motor overloaded
Item 61285
Solution
All damaged parts need to be exchanged
before using it.
Contact a qualified technician.
All maintenance work needs to be carried
out by a qualified technician.
Exchange the blown fuse. Turn all other
devices connected to the same electric cir-
cuit off.
Apply less pressure to the work piece and
thus to the surface being processed.
Clean the cutting mechanism.
Exchange the cutting disc.
Adjust the rip fence correctly.
Clean the machine.
Reduce the engine load. Allow the engine to
cool down before continuing to work.
Page 10
03
2021-1
Advertisement
