Advertisement
Quick Links
Operation Manual
360° Metal Sheet Bending Machine
61856
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignificant-
ly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Related Manuals for WilTec 61856
Summary of Contents for WilTec 61856
- Page 1 Operation Manual 360° Metal Sheet Bending Machine 61856 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignificant- Updating the documentation If you have suggestions for improvement or have found any irregularities, please contact us.
- Page 2 All rights reserved. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
- Page 3 Do not use the tool if under the influence of alcohol, drugs or medicine, that alter your con- sciousness. • Never stand on the tool. Should the tool tilt over, serious injuries or damages might follow. © by WilTec Wildanger Technik GmbH Item 61856 Page 3 http://www.WilTec.de http://www.aoyue.eu...
- Page 4 Consider the “spring-back” effect. 10. Should you wish to repeat bends at the same angle, firmly tighten the stop at the spot where you have finished the bending operation. © by WilTec Wildanger Technik GmbH Item 61856 Page 4 http://www.WilTec.de...
- Page 5 (depending on the length of your workpiece). Thus, the bend- ing is “stopped” at the right position. 11. Should you wish to repeat bends at another angle, use the stop (2). © by WilTec Wildanger Technik GmbH Item 61856 Page 5 http://www.WilTec.de...
- Page 6 8. Now set the spring pins (25) of the spring-forming die “B” (30) into the holes 4 and 5. 9. Finish bending by completely bending the piece around the dies. Figure 2 Figure 3 © by WilTec Wildanger Technik GmbH Item 61856 Page 6 http://www.WilTec.de http://www.aoyue.eu...
- Page 7 Exploded view and parts list © by WilTec Wildanger Technik GmbH Item 61856 Page 7 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 8 Mounting disc for spring-forming die 1 Important notice: The reprint or reproduction, even of excerpts, and any commercial use, even in part, of this instruction manual require the written permission of WilTec Wildanger Technik GmbH. © by WilTec Wildanger Technik GmbH Item 61856 Page 8 http://www.WilTec.de...