McCulloch B26PS Operator's Manual page 17

• Choke: Your unit is designed with a 3 position choke:
Full choke, half chokeand Run position. Set the choke
control in the choke position.
• Squeeze throttle trigger in full position.
WARNING! When the engine is started
!
with full throttle the cutting attachment
will start to rotate immediately.
• Primer bulb: Press the air purge 10 times.
• Wait 10 seconds.
• Make quickly and powerful pulls with the starter
handle, max. 6 times. Never twist the starter cord
around your hand.
CAUTION! Do not pull the starter cord all the way out and
do not let go of the starter handle when the cord is fully
extended. This can damage the machine.
STARTING AND STOPPING
x10
• Move the choke lever to Half Choke position as soon
as the engine sounds as if it is trying to start.
• Pull starter cord while trigger is in the full throttle
position until engine starts.
• Once engine is started leave the choke lever in Half
choke position for 20 seconds. Then move the choke
lever to RUN position.
If engine does not start move the choke lever to Full
Choke position and do the steps again.
WARNING! When the engine is started
!
with full throttle the cutting attachment
will start to rotate immediately.
–
English 17