Connecting The Monitor; Audio System; Setting The Refresh Rate - Prestigio P575 Manual

• To reduce eye strain, avoid installing the display unit against a bright background such as a window.
• Position the monitor so that the top of the screen is no higher than eye level.
• Position the monitor directly in front of you at a comfortable reading distance (around 45 to 90cm).
Before you start cabling your monitor, check that the power is off on all units.
To avoid any possibility of electric shock, always connect your equipment to properly earthed
outlets.

Connecting the monitor

1. Insert the 15-pin signal cable connector into the 15-pin VGA connection on your computer and on the monitor and
screw it down.
2. Plug adapter output cable to the jack at the rear of LCD monitor and the power cord to the adapter.
3. Connect the power cord to power source.
4. Turn on the computer and the monitor.
5. Turn on the power to the computer. The picture will appear within about 10 seconds. Adjust the picture to obtain
optimum picture quality. See section Adjusting the picture in this guide for more information.

Audio system

This monitor has an audio system including two micro loudspeakers. Each of two micro loudspeakers has 2 Watts output
power.

Setting the refresh rate

Follow the instructions below to set your refresh rate in Windows 98/ME/XP/2000.
1. Go to the configuration window (Start-Settings-Configuration window).
2. Double click on the 'Display' icon.
3. Click on the 'Settings' tab.
4. Click on the 'Advanced' button.
5. Click on 'Adapter' and select 60Hz from the list.
6. Click on 'Apply' to accept the selected value.
PRESTIGIO P575 / PRESTIGIO P595
SPEAKERS
3