Bryant LEGACY 558J Product Data page 44

LEGEND
C --- Contactor, compressor
CAP --- Capacitor
CB --- Circuit breaker
CCH --- Crankcase heater
COMP --- Compressor motor
DDC --- Direct digital control
FU --- Fuse
GND --- Ground
HPS --- High pressure switch
IAQ --- Indoor air quality sensors
IFC --- Indoor fan motor
IFM --- Indoor fan motor
LA --- Low ambient lockout
LPS --- Low pressure switch
NOTES:
1. If any of the original wire furnished must be replaced, it must be replaced with type 90 C wire or its equivalent.
2. Compressor and fan motors are thermally protected. Three phase motors are protected against primary single phasing
conditions.
3. On 208/230V units, transformer is wired for 230V. If unit is to be run with 208V power supply, disconnect black wire from
230V tap and connect to 200V tap. 230V, 200V taps on transformer do not appear on 575V transformer and 575V tap does
not appear on 208/23/460V transformer.
4. Use copper, copper clad, aluminum or aluminum connectors.
5. Use copper conductor only.
Fig. 13 - - Typical Power Diagram
LSM
MGV
OAT
OFM
OLR
PL
POT
PMR
QT
R
RAT
SAT
TDR
TRAN
44
--- Limit switch (manual reset)
--- Main gas valve
--- Outdoor air temp sensor
--- Outdoor fan motor
--- Overload relay
--- Plug assembly
--- Potentiometer
--- Phase monitor relay
--- Quadruple terminal
--- Relay
--- Return air temp sensor
--- Supply air temp sensor
--- Time delay relay
--- Transformer
C08054