Operation - Makita XAG24 Instruction Manual

1. To install the X-LOCK wheel, make sure that both
catches are in the unlocked position.
If not, push the release lever from A side to lift B
side, then pull the release lever from B side as
illustrated. The catches are set in the unlocked
position.
1
2
A
► 1. Catch 2. Release lever
2. Place a central position of the X-LOCK wheel on
the holder.
Make sure the X-LOCK wheel is parallel to the
flange surface and with the correct side facing up.
3. Push the X-LOCK wheel into the holder. The
catches snap into the lock position with a click and
fix the X-LOCK wheel.
3
4
► 1. X-LOCK wheel 2. Holder 3. Flange surface
4. Catch
4.
► 1. Surface of the holder 2. Surface of the X-LOCK wheel
B
To remove the X-LOCK wheel, push the release lever from A side
to lift B side, then pull the release lever from B side as illustrated.
The X-LOCK wheel is released and can be removed.
► 1. Release lever
1

OPERATION

2
tool. The weight of the tool applies adequate pressure. Forcing
and excessive pressure could cause dangerous wheel breakage.
dropped while grinding.
wheel, especially when working corners, sharp
edges etc. This can cause loss of control and kickback.
and other saw blades. Such blades when used on a grinder fre-
quently kick and cause loss of control leading to personal injury.
X-LOCK holder during operation. The X-LOCK wheel
comes off from the tool and may cause serious injury.
is fixed firmly.
13 ENGLISH
Make sure the X-LOCK wheel is fixed correctly.
The surface of the X-LOCK wheel is no higher than
the surface of the holder as shown in the figure.
If not, the holder must be cleaned or the X-LOCK
wheel must not be used.
2
A
WARNING:
It should never be necessary to force the
WARNING:
ALWAYS replace wheel if tool is
WARNING:
NEVER hit the workpiece with the wheel.
WARNING:
Avoid bouncing and snagging the
WARNING:
NEVER use tool with wood cutting blades
WARNING:
Never actuate the release lever of the
WARNING:
Make sure that the X-LOCK wheel
1
B
1