Advertisement
3. The drain belt is too long or
4. The drain hose hook is too
5. The flexibility of compress
6. There is any exterior in the
1. The wash tub is broken.
Water leaks from
2. The
the
sides
when
washing
3. The rubber seal ring on the
4. The overflow pipe is cracked.
5. The rubber sleeve of drain
6. The
Water leaks from
1. The outlet of drain hose or
the drain hose
2. The drain belt is too tight.
3. The flexibility of compress
Noise occurs from
1. Exterior material under the
the impeller during
rotating
2. The fasten screw of impeller
3. The
4. The lock screw of the big
5. Motor fan and big impeller
6. The
7. Big
Maintenance of Twin Tub Washing Machine
is broken.
high.
spring of drain valve is too
large.
drain outlet of wash tub or
rubber sleeve of drain valve.
seal
ring
reducer is broken.
speed reducer and wash tub is
broken.
valve is cracked.
drain
elbow
joint did not connect well.
the drain valve is jammed.
spring is not enough.
impeller.
is loose.
gear
wheel
reducer is damaged.
impeller is loose.
are not in the same level.
surface
of
harsh.
noise
from
motor.
4. Rehang the drain hose hook on the hole
under the pull-rod.
5. Replace the compress spring.
6. Open the cover of drain valve, take out the
rubber sleeve of drain valve and clean it.
of
speed
1. Replace wash tub.
2. Replace the speed reducer.
3. Replace the rubber seal ring.
4. Replace the overflow pipe.
5. Replace the rubber sleeve of drain valve.
6. Reinstall the drain elbow or drain joint.
or
drain
1. Open the cover of drain valve, take out the
rubber sleeve of drain valve and clean it.
2. Adjust the position of the hook of drain belt
and the pull-rod of drain valve.
3. Replace the compress spring.
1. Remove the impeller and take out the
exterior material.
2. Tighten the fasten screw.
in
speed
3. Replace the speed reducer.
4. Tighten the lock screw.
5. Adjust the motor fan until it's in the same
level as big impeller.
6. Replace another V-belt.
7. Replace the wash motor.
V-belt
is
the
wash
4
Advertisement
