Lenovo HR630X V2 User Manual page 55

Step 2. Align the rear backplane with the rear hot-swap drive cage and lower it into the rear hot-swap drive
cage.
Figure 21. Rear backplane installation
Step 3. Connect the signal cable and the power cable on the rear backplane.
Step 4. Install the air baffle into the rear hot-swap drive cage as shown.
Figure 22. Air baffle installation
After you finish
1. Reinstall the drives or drive fillers into the rear hot-swap drive cage. See "Install a hot-swap drive" on
page 38.
2. Reinstall the drive assembly to the server. See "Install the hot-swap rear drive assembly" on page 49.
3. Complete the parts replacement. See "Complete the parts replacement" on page 110.
.
Chapter 4 Hardware replacement procedures
47