Operation; Turning The Power On And Off - A&D EK-i Series Quick Start Manual

EN る

5-1 Turning the power ON and OFF

1. Press the
All of the indicators are displayed as shown above.
(About units: Only the units available will be displayed.)
The display turns off except for a weighing unit and the decimal point.
The balance waits for the weight data to become stable, and zero will be displayed with the ZERO
mark (power-on zero).
The range for power-on zero is within ±10% of the weighing capacity around the calibrated zero
point.
If the power is switched ON while there is a load beyond this range, the balance will be tared to
zero and the NET mark and the ZERO mark turn on.
2. Pressing the

5. Operation

key to turn the power ON.
key again, and the power will be switched OFF.
6