24
Installation Guidelines
3.3.1
DC Output Terminal Block
The DC Output Terminal block on the rear of the T809-10 is a Phoenix Contact HDFKV
10. This is a screw-type terminal connector that uses a cage mechanism to clamp the
conductor(s).
When installing:
• Use a stripping length of 11mm.
• Do not twist the strands of the conductor prior to clamping.
• Securely fasten the conductor(s) with a tightening torque of 1.5Nm (recom-
mended minimum).
• Observe maximum wire cross-sections as outlined in the table below.
Conductor Type
Flexible (stranded)
Solid
Flexible with ferrule and
plastic sleeve
Flexible with ferrule
without plastic sleeve
Flexible with twin ferrule
and plastic sleeve
† These conductors use the same cross-section
3.3.2
Auxiliary Inputs Connector
The 9-way D-range connector on the T809-10 rear panel (auxiliary inputs) provides
access to the remote control and remote sense functions of the power supply. For con-
nection details, refer to Sections 3.5 (Remote Sense) and 3.6 (Remote Control).
November 2004
Number of
Conductors
1
10mm
†
2
4mm
1
16mm
†
4mm (each)
2
1
10mm
†
2
2.5mm
1
10mm
2
6mm
Maximum Cross-section
2
(AWG = 6)
2
(each)
2
2
2
2
2
Copyright © 2004 Tait Electronics Ltd
MBZ-00001-01