Power Supply Cord (Ac Input) - Tait T809-10 Service Manual

22 Installation Guidelines
Wire Temperature/Insulation
105°C PVC or Neoprene
These values are a guideline only. Smaller wire gauges may be used for
Note:
lower operating temperatures. Check with the wire manufacturer's specifi-
cations to ensure safe and proper use.
3.2.2.4 Between Protection Device and Load
The wire lengths running between the protection device and the load only need to be of
sufficient gauge to:
• Carry the required load current (at maximum operating temperature).
• Ensure that voltage drop between the power supply output and the load
does not exceed 0.3V – when the remote sense feature is connected.
The minimum recommended wire sizes for a maximum operating temperature of 60°C,
are as follows:
Load
25A load (T800 subrack with 100W PA)
15A load (T800 subrack with 50W PA)
Note: The recommended wire insulation temperature rating for all output wiring
is 105°C.
3.2.3

Power Supply Cord (AC Input)

For the AC input connection:
• Use only an IEC type power supply cord.
• Ensure the power supply cord has a current rating of at least 10A.
• Ensure that the power supply cord is approved in the country of use and meets
the local electrical safety regulations.
November 2004
Wire Gauge
2
5mm CSA (10AWG)
Wire Gauge
2
3.3mm CSA (12AWG)
2
2mm CSA (14AWG )
Copyright © 2004 Tait Electronics Ltd
MBZ-00001-01