Cleaning And Care; Delivery Set; Technical Specifications - Maxwell MW-2027 GY Manual Instruction

Overheating protection
Overheating protection switches the haird-
ryer off if the outgoing air flow is too hot. If
the hairdryer switches off during operation,
set the operation mode switch (1) to the "0"
position, unplug the hairdryer and make sure
that the inlets and outlets are unblocked. Let
the hairdryer cool down for 5-10 minutes and
switch it on again. Do not block the air inlets
during unit operation and avoid getting of hair
into its air inlet.

CLEANING AND CARE

–
The hairdryer is intended for household
use only.
–
Set the switch (1) to the position «0» and
disconnect the hairdryer from the mains.
–
You may wipe the unit body with a damp
cloth and then wipe it dry.
–
Clean the air inlet grid (4) with a brush.
–
Never immerse the unit into water or other
liquids.
–
Do not use abrasives and solvents to clean
the unit body.
STORAGE
–
Unplug the hairdryer if you are not using it.
–
Let the hairdryer cool down after its usage,
keep the unit away from children in a dry
cool place.
–
Never wind the power cord around the hair-
dryer, as this can damage the cord. Handle
the power cord with care, do not pull, twist
or stretch it, especially near the power plug
M MW-2027.indd 5
or at the junction point. Straighten the cord
periodically if it gets twisted.
–
For easy storing there is a hanging loop (6),
you can hang the unit on this loop provided
that no water gets on the unit in this posi-
tion; you can fold the handle (5) to minimize
the hairdryer size.

DELIVERY SET

Hairdryer – 1 pc.
Nozzle attachment – 1 pc.
Manual – 1 pc.

TECHNICAL SPECIFICATIONS

Supply voltage: 220-240 V ~ 50 Hz
Power consumption: 1400-1600 W
The manufacturer preserves the right to
change the specifications of the units without
a preliminary notification
Unit operating life is 3 years
Guarantee
Details regarding guarantee conditions can be
obtained from the dealer from whom the appli-
ance was purchased. The bill of sale or receipt
must be produced when making any claim
under the terms of this guarantee.
This product conforms to the EMC-
Requirements as laid down by the Council
Directive 2004/108/ЕС and to the Low
Voltage Regulation (2006/95/ЕС)
5
ENGLISH
06.10.2016 15:22:00