Using The Hairdryer - Maxwell MW-2027 GY Manual Instruction

ENGLISH
•
For children safety reasons do not leave
polyethylene bags used as packaging unat-
tended.
ATTENTION! Do not allow children to play with
polyethylene bags or packaging film. Danger
of suffocation!
•
Do not allow children to touch the unit body,
the power cord or the power plug during
operation of the unit.
•
Do not leave children unattended to pre-
vent using the unit as a toy.
•
Close supervision is necessary when chil-
dren or disabled persons are near the oper-
ating unit.
•
This unit is not intended for usage by chil-
dren. Place the unit out of reach of children
during the operation and cooling down.
•
The unit is not intended for usage by physi-
cally or mentally disabled persons (includ-
ing children) or by persons lacking experi-
ence or knowledge if they are not under
supervision of a person who is responsible
for their safety or if they are not instructed
by this person on the usage of the unit.
•
Children can use the unit ONLY under super-
vision of a person, who is responsible for
their safety, and if they are given all the
necessary and understandable instructions
on safety measures and information about
danger, that can be caused by improper
usage of the unit.
•
To avoid damages, transport the unit in the
original package only.
•
Do not attempt to repair the unit. Do not
disassemble the unit by yourself, if any mal-
function is detected or after it was dropped,
unplug the unit and apply to any authorized
service center from the contact address list
given in the warranty certificate and on the
website www.maxwell-products.ru.
•
Keep the unit in a dry cool place out of reach
of children and disabled persons.
•
Do not use the unit outdoors.
•
For environment protection do not discard
the unit with usual household waste after its
M MW-2027.indd 4
service life expiration; apply to a specialized
center for further recycling.
THE UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY

USING THE HAIRDRYER

After unit transportation or storage at low
temperature keep it for at least three hours
at room temperature before switching on.
–
Before switching the unit on, make sure that
your home mains voltage corresponds to
the unit operating voltage.
–
Remove any stickers that can prevent unit
operation.
–
Unwind the power cord completely.
–
Insert the power plug into the mains socket.
–
Select the required operation mode using
the switch (1):
«0» – the hairdryer is switched off;
«1» – supply of warm air at low flow speed;
«2» – supply of hot air at maximal flow speed.
Note: During the first operation some foreign
smell and a small amount of smoke from the
heating element is possible, it is normal.
–
This model has a "cool shot" function
use it to fix your hairstyle. To switch "cool"
air supply on, press and hold down the but-
ton (2) .
–
After unit operation, switch the hairdryer off
by setting the switch (1) to the position «0»,
and unplug it.
Nozzle
This model includes a nozzle (3). Use the
nozzle when you need to focus the drying
power on a small area (for example, a curl
or a wave) or when you want to straighten
wavy hair.
–
Attach the nozzle (3) to the unit body.
The nozzle allows directing a narrow air flow
of high intensity at a definite hair lock.
–
Insert the power plug into the mains sock-
et. Use the switch (1) to set the necessary
operation mode.
4
,
06.10.2016 15:22:00