Maxwell MW-2002 - Hair Dryer Manual

Description

1. Air inlet grid
2. Operating modes switch (0/1/2)
3. Handle
4. Hanging loop
5. Cool button

ATTENTION! Do not use the unit near objects filled with water (bath, swimming pool etc.).

• When using the hair dryer in a bathroom, disconnect it immediately after usage, pull the plug out of the socket, as when water is near it is dangerous even if the switch is off;
• For additional protection you can install a residual current device with nominal current of operation, not exceeding 30 mA into the mains of the bathroom while installation refer to a specialist;

IMPORTANT SAFEGUARDS

Carefully read and follow the operating instructions, keep them for future reference!

To protect against risk of a fire or electric shock:

• Before using, make sure that your home electricity supply corresponds to the voltage specified on the housing of the unit.
• Use the hair-dryer only for its functions and only with attachments included in a set.
• Never leave the operating hair-dryer unattended.
• Do not use the hair-dryer near aero-sols or inflammable liquids.
• Always unplug the hair-dryer immedi-ately after using and before cleaning. Hold by the plug; do not pull by the cord.
• Do not touch the plug with wet hands.
• Do not place or store the appliance where it can fall into a tub or sink, filled with water; do not immerse the unit into water or other liquids.
• Do not use while bathing.
• When using the hair dryer in a bath-room, disconnect it immediately after usage, pull the plug out of the socket, as when water is near it is dangerous even if the switch is off.
• If the hair-dryer falls into water, unplug it immediately. And only then you can take it out of the water.
• When children or disabled people use a hair-dryer it is necessary to be especially careful. Children are allowed to use the unit only if they are given all the necessary instructions concerning using of the unit and injuries that can appear due to improper usage of the unit.
• Do not use the unit when you are drowsy.
• Hold the unit by the handle.
• Do not use the unit to style wet hair or synthetic wigs.
• Do not direct hot air into your eyes or other parts of your body, which are sensitive to heat.
• Avoid contact of heated surfaces with your face, neck and other parts of your body.
• Attachments get hot during use. Allow them to cool before removal.
• Never drop or insert any object into any openings of the body.
• Never block the air openings of the appliance or place it on a soft surface, such as a bed or couch, where the air openings may be blocked. Keep the air openings free of lint and hair etc.
• Avoid getting of hair into air inlet grid during operation of the unit.
• Before using of the unit unwind the cord at full length.
• The power cord should not:
  • touch hot objects,
  • run through sharp edges,
  • be used as a handle.
• Periodically check the integrity of the power cord.
• Never use the unit if the power cord, plug is damaged; if the unit malfunctions or after it fell into water. Apply to the authorized service centre for repair.
• Before you take the unit away, let it cool down, do not wind the power cord around the unit.

THE UNIT IS INTENDED FOR HOUSEHOLD USAGE ONLY.

Switching on of the device

Before using, make sure that your home electricity supply corresponds to the voltage specified on the housing of the unit.

• Unwind the power cord completely.
• Insert the plug into the socket.
• Use the switch (2) to set the required operation mode:
  «0» – off;
  «1» – low heat and speed for hair drying and styling;
  «2» – high heat and speed for quick drying and sophisticated hair-do;

Cool shot

This model has cool button for fixing up your hair. Press and hold cool button (6). It will let you keep the created style.

Hair Care

To get best results (before drying or styling) wash your hair, dry it with a towel and comb your hair.

Quick drying

Set the switch (2) to maximal heating "2". Remove unnecessary moisture from hair and move the hair-dryer above your hair.

Concentrator

• Connect the concentrator (5) to the body of the unit. This attachment allows directing narrow air flow of high intensity to a certain lock of hair.
• Plug the unit. Use the switch (2) to set the required operation mode.

Overheating protection

The unit has a protection from overheating, which will switch off the unit if the temperature of output air increases. If the unit switches off while operation, switch it off with the switch (2), setting it to the "0" position, take the plug out of the socket, make sure that the air openings are not blocked, let the unit cool down for 5-10 minutes and switch it on again. Do not block air openings during usage of the unit; avoid getting of hair into the air inlet grid.

Clean and care

The unit is intended for household usage only.

• Set the switch (2) to the "0" position and disconnect the hair-dryer.
• The case of the hair-dryer can be cleaned with a wet cloth. After it, it is necessary to dry the case.
• Never immerse the body of the appli-ance into water or other liquids.
• Do not use abrasives and solvents to clean the unit.

Storage

• Always unplug the hair-dryer if it is not being used.
• After using let the hair-dryer cool off and keep it in a dry place away from children.
• Never wind the cord around the hair-dryer. It can cause the damage of the hair-dryer. Do not pull, overturn or strengthen the cord especially near the plug and at the place where the hair-dryer is fastened to the body. Strengthen the cord if it is overturned.
• For easy storing there is a loop for hang-ing-up (4) on the unit, you can keep the unit by means of this loop provided that no water gets on the unit.

SPECIFICATIONS

Power supply: 220-240 V ~ 50 Hz
Power: 1600 W

The manufacturer shall reserve the right to change the specification of the appliances without preliminary notice.

The life time of the appliance - 3 years

Guarantee

Details regarding guarantee conditions can be obtained from the dealer from whom the appliance was purchased. The bill of sale or receipt must be produced when making any claim under the terms of this guarantee.

This product conforms to the EMC-Requirements as laid down by the Council Directive 89/336/EEC and to the Low Voltage Regulation (73/23 EEC)

A production date of the item is indicated in the serial number on the technical data plate. A serial number is an eleven-unit number, with the first four figures indicating the production date. For example, serial number 0606ххххххх means that the item was manufactured in June (the sixth month) 2006.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Maxwell MW-2002 - Hair Dryer Manual