Table of Contents
Advertisement
- staff kitchen areas in shops, offices and other working
environments.
- by clients in hotels, motels, bed & breakfast and other
residential type environments.
- areas for communal use in blocks of flats or in launderettes.
The operating water pressure at the water entry point from the
•
outlet connection must be between 0.3 bar (0.03 MPa) and 8
bar (0.8 MPa).
The ventilation opening in the base must not be covered by a
•
carpet, mat, or any floor covering.
The appliance must be connected to the water mains using the
•
new supplied hose sets, or other new hose sets supplied by
the Authorised Service Centre.
Old hose sets must not be reused.
•
If the mains power supply cable is damaged, it must be
•
replaced by the manufacturer, its Authorised Service Centre or
similarly qualified persons to avoid an electrical hazard.
Before any maintenance operation, deactivate the appliance
•
and disconnect the mains plug from the socket.
Do not use high pressure water sprays and/or steam to clean
•
the appliance.
Clean the appliance with a moist cloth. Use only neutral
•
detergents. Do not use abrasive products, abrasive cleaning
pads, solvents or metal objects.
SAFETY INSTRUCTIONS
INSTALLATION
The installation must comply with
relevant national regulations.
•
This washing machine is for indoor use only.
•
The appliance is not intended to be used as
built-in
•
The openings must not be obstructed by any
means, such like a carpet.
•
Washing machine shall not be installed in the
rooms with dangerous materials or caustic
gases.
Remove all packages, transport bolts, motor
protection before using the appliance.
Otherwise, serious damage may result.
•
The product with double inlet valves should be
correctly connected to the hot water and cold
water supply. The washing machine with single
inlet valve only have to be connected to the cold
water supply.
•
Plug must be accessible after installation.
•
Do not climb up and sit on top cover of the
machine.
•
Do not lean against machine door.
•
Cautions during Handling Machine:
– Transport bolts, motor protection shall be
reinstalled to the machine by a specialized
person "if included".
– The accumulated water shall be drained out
of the machine.
3
Advertisement
Table of Contents
