Table of Contents
Advertisement
Problems without alarm messages
Description
The appliance is not washing
No water flows in
Abnormal draining
Abnormal spin
If the problem occurs again, contact the Authorised Service Centre.
TECHNICAL DATA
Dimension
Electrical connection
Level of protection against ingress of solid particles and moisture
ensured by the protective cover, except where the low voltage
equipment has no protection against moisture.
Water supply pressure
1)
Water supply
Maximum load
14
If the power is off or the fuse is burned out.
If the power supply voltage is too low.
If the water amount reaches to the required water level.(The
washer will not work if the water amount does not reach the re-
quired water level)
If it is set to "Delay" washing mode. (It will only start to work until
the reservation time reached)
If the power is off or the fuse is burned out.
If the water supply is cut off or the water pressure is too low.
If the inlet hose is properly connected and the water tap is
opened.
If the filtering screen of inlet valve is blocked by dirt.
If the coil of inlet valve is damaged. (The slight electromagnetic
sound is normal phenomenon when the inlet valve is switched
on)
If the "Start / Pause" button is pressed after the power switch is
pressed.
If the water drain hose is placed very high.
If the end of water drain hose is sealed in pond.
If the internal rubber ring of drain valve is blocked by dirt.
If the door lid is not closed properly.
If all clothing piled largely at one side of barrel or the clothing is
excessively placed.
If the washer is not placed in stable condition or it is placed in
inclination state. (The ground is not flat).
If the motor belt is loosened.
Height x Width x Depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
Inspection Items
965mm x 550mm x 578mm
220-240 V
510 W
10 A
50 Hz
IPX4
0.3 bar (0.03 MPa)
8 bar (0,8 MPa)
Cold water
Hot water
10 kg
Advertisement
Table of Contents
