Setting The Phototest Operation; Setting The Tension Release - Nice SPIDO Instructions And Warnings For Installation And Use

7.7 SETTING THE PHOTOTEST OPERATION

Function found in the PHOTOTEST CONFIGURATION menu
(OUT2).
This function allows for modifying the operating setting of the PHO-
TOTEST (OUT2) output.
Using the f and
values present in the underlying table. To confirm it, press the
g
button.
PHOTOTEST (OUT2) OUTPUT SETTING
Value Description
Phototest
Allows for verifying, at the start of a manoeuvre,
the correct operation of all the safety devices
(see the "Photocells with PHOTOTEST function"
paragraph on page 27).
(Default)
Note: Whenever this setting is chosen, the devices
must be learned again (see "Programming the door
opening and closing positions").
24 V DC 3 W output
Door status
This function allows for activating the output when the
motor is moving.
Output active 24 V DC / max 3W
Electric lock
When the opening manoeuvre is performed, the electric
lock activates for 3 seconds.
Output active 24 V DC / max 3W
Electric latch
When the opening manoeuvre is performed, the
electric lock activates. It is not active during the closing
manoeuvre.
Output active 24 V DC / max 3W
Suction cup
The suction cup activates when the application is
in the fully closed position; in all other situations it is
deactivated. When the suction cup deactivates, before
an opening manoeuvre starts there is a 3-second delay.
Output active 24 V DC / max 3W
Courtesy light
When the manoeuvre is performed, the output activates
and stays activated for 1 minute after the end of the
manoeuvre.
Output active 24 V DC / max 3W
Radio channel 1
If this radio channel is set, the output activates when a
command is sent with the transmitter.
WARNING! If this radio channel is not free on the control
unit receiver, due to having being previously memorised
with a command, the control unit will only activate the
programmed output when the channel is activated with
the transmitter, ignoring the command towards the
motor.
Output active 24 V DC / max 3 W
Radio channel 2
Like setting no. 6, on radio channel 2.
Radio channel 3
Like setting no. 6, on radio channel 3.
Radio channel 4
Like setting no. 6, on radio channel 4.
20 – ENGLISH
h buttons, select one of the

7.8 SETTING THE TENSION RELEASE

Function found in the TENSION RELEASE menu.
This function allows for releasing the mechanical tension that ac-
cumulates in the components after every manoeuvre. When the
closing position is reached, the motor will perform a brief inversion
to release the belt or chain tension.
Using the f
values present in the underlying table. To confirm it, press the
g button.
Table 9
a
At the end of the operation, the automation will ask
to run the automatic force search procedure, sig-
nalling it with the flashing courtesy light (consult
the "Automatic force search" chapter on page 14).
TENSION RELEASE SELECTION
Value Description
Release deactivated
Minimum release
...
...
...
Medium release
(Default)
...
...
...
Maximum release
and h buttons, select one of the
Table 10