Yamaha DTX-PRO Reference Manual page 140

Troubleshooting
Symptom
Pads are only produc-
ing sounds at very high
volumes (i.e., high
velocities)
Pads produce
unintended sounds
Sounds are distorted
Sounds play endlessly
and do not stop
Effects cannot be
applied
The wave tempo does
not change
Pad controller does not
work
By pressing the [REC]
button, only one song
can be recorded. The
previous recording is
overwritten
My training scores are
strange
Possible cause
• Ensure that the "Gain" parameter from MENU/Trigger/Pad Type
or TRIGGER/SETTING/Pad Type is not set too high.
• Adjust the "Velocity Curve" parameter from MENU/Trigger/
Curve or TRIGGER/SETTING/Curve.
• Check the "TrgVel" setting in MENU/Kit Edit/Kit Modifier/Voice/
MessageType. For example, if this parameter is set to "127," the
maximum velocity will be produced even when the pad is struck
lightly.
• Ensure that you are using only the recommended Yamaha pads.
Products from other manufacturers can output excessively large
signals.
• Ensure that trigger setups have been configured correctly.
• If an external MIDI device played from the PRO series module
does not produce the expected sounds, review its voice settings
for the MIDI channel on which the PRO series module is sending
data, and ensure that they are appropriate for the MIDI data
being sent.
• Voices assigned to layers B, C, or D may cause unintended
sounds.
• In some cases where unexpected sounds are produced when
you have connected a two or three-zone pad to any of the
w
[ TOM1/
q
[ SNARE] or [
13, set the "Pad Type" parameter to "off" in MENU/Trigger/Pad
Type or TRIGGER/SETTING/Pad Type. With Pad 1 or Pad 14,
select the proper pad type in MENU/Trigger/Pad Type or TRIG-
GER/SETTING/Pad Type.
• Check the crosstalk setting, min level setting and sensitivity set-
ting.
• Ensure that effects have been set appropriately. Sound can be
distorted with certain combinations of effect type and parameter
settings.
• Ensure that the "VoiceFilter" parameter in MENU/Kit Edit/Voice
is configured properly. Depending on the VoiceQ settings (filter
resonance), distortion can be caused.
• Lower the PRO series module's master volume.
Ensure that the hold function is not turned on.
Press [EXIT] while on the kit screen (top screen) to stop the KIT
sounds.
• Ensure that the [EFFECT] knob is not turned down to minimum.
• Ensure that the effect type is not set to "THRU" or "NO EFFECT."
• Ensure that the InstSend value is high enough for Effect 1 or
Effect 2.
Wave tempo cannot be changed. It will always play at the original
tempo of the imported file regardless of kit tempo and other set-
tings.
Pad controllers are not supported.
Only one song can be recorded to the PRO series modules.
Crosstalk is occurring See the section on
Solution
DTX-PRO
e r t y u
], [ TOM2/ ], [ TOM3/ ], [
!4
] jacks. If so, with Pad 3, Pad 5, Pad 7 or Pad
Effects may not be applied to
the output via Indiv Out. Master
effects will not be applied.
Insertion effects may not be
applied depending on the set-
tings.
"Crosstalk."
DTX-PRO DTX-PROX Reference Manual
DTX-PROX
!2 !3
K ICK/ ] ,
140