Table of Contents
Advertisement
LAMPADAPTERPLA TEMOUNTINGINSTALLA TION
1. Remove the adapter plate kit hardware from its
container.
2. Before proceeding make sure the light tower mast is
inthestowposition(down) andthecradlelock/release
pin has been inserted and the mast is locked.
3. Attach the lamp adapter plate to the T -Bar as shown
in Figure 7. Align adapter platesothat adapter spacer
notch fits over screw on T -Bar. Pay close attention to
the orientation of the two support brackets.
4. Mount the flat end of both support brackets flush
against the T -Bar with the low end of each bracket
facing inwards toward the mast. The raised end of
each bracket should be facing outward.
NOTICE
Paycloseattentiontotheorientationof thetwosupport
brackets.Eachbracket hasahighandlowside.Thelow
side of the bracket should be facing inwards towards
the mast.
PA GE 20 —GB4000 BALLOON LIGHT• OPERA TION AND PARTS MANUAL —REV . #1 (02/25/14)
5. Next, insert a bolt (4) and flat washer (4) thru the
mountingholesontheadapter plateasshowninFigure
7. Again, pay close attention on which set of holes to
insert the bolts thru. Bolt number 2 must be oriented
so that it passes between receptacles J1 and J2 on
the T -Bar.
6. Securetheadapter platetotheT -Bar usingthesupplied
flat washer (4), lockwasher (4) and nut (4). Makesure
the adapter plateislevel (useabubble level) and both
brackets are straight (vertical), not slanted, before
tightening.
SETUP
Advertisement
Table of Contents
