Maintenance - Bostitch BFN21PL Operation And Maintenance Manual

MAINTENANCE

Disconnect air line from tool, engage trigger lock and remove
fasteners from magazine before making adjustments or personal injury may
result.
DAILY MAINTENANCE CHART
ACTION
Lubricate tool with 5-7
drops of BOSTITCH
Pneumatic Tool Oil
Drain compressor tanks
and hoses daily
Clean magazine, magazine
release and contact
trip mechanism.
Before each use, check
to insure all screws,
nuts and fasteners are
tight and undamaged.
CLEANING
Never use solvents or other harsh chemicals for cleaning the
non-metallic parts of the tool. These chemicals may weaken the materials used in
these parts. Use a cloth dampened only with water and mild soap. Never let any
liquid get inside the tool; never immerse any part of the tool into a liquid.
REPAIRS
For assistance with your tool, in the U.S. you may call us at 1-800-556-6696 or
visit www.BOSTITCH.com for the location most convenient for you. In Canada
please call us at 1-800-567-7705 or visit www.BOSTITCH.com.
IN ADDITION TO THE OTHER WARNINGS CONTAINED IN THIS MANUAL
OBSERVE THE FOLLOWING FOR SAFE OPERATION
• Use the BOSTITCH pneumatic tool only for the purpose for which it was designed.
• Never use this tool in a manner that could cause a fastener to be directed toward the user or
others in the work area.
• Do not use the tool as a hammer.
• Always carry the tool by the handle. Never carry the tool by the air hose.
• Do not alter or modify this tool from the original design or function without approval from
BOSTITCH, INC.
WHY
Prevents failure
of o-rings
Prevents accumulation
of moisture in
compressor and nailer
Permits smooth
operation of magazine,
reduces wear and
prevents jams.
Prevents jams, leaks
and premature failure
of tool parts.
– 14 –
HOW
Insert drops into air fitting
on end cap of tool
Open petcocks or
other drain valves on
compressor tanks. Allow
any accumulated water
to drain from hoses
Blow clean with
compressor air. The
use of oils, lubricants
periodically or solvents is
not recommended as they
tend to attract debris.
Tighten loose screws
or other fasteners using
the appropriate hex
wrench or screwdriver.