Self-Test In Accordance With Enel Guideline (Only For Italy); Starting The Self-Test By Tapping - SMA SUNNY TRIPOWER 8000TL Installation Manual

Commissioning
7.3 Self-test in accordance with ENEL guideline (only for Italy)
7.3.1 Starting the Self-Test by Tapping
You can start the self-test by tapping on the enclosure lid. The country configuration of the inverter
must be set to Italy (Enel-GUIDA) or a reconfigured based on the Enel-GUIDA country data set before
the self-test can be carried out. In addition, an undisturbed feed-in operation must be possible.
Display language during the self-test
Independent of the configured language, the display messages for the self-test will always
be displayed in Italian.
Proceed as follows for checking the disconnection times:
1. Commission the inverter as described in section 7 "Commissioning" (page 61).
☑ The inverter is now in the start phase.
– Firstly, the firmware version of the internal processors appears in the text lines.
– After 5 seconds or after tapping the enclosure lid, the serial number or the description of
the inverter appears. The description of the inverter can be changed with a
communication device.
– After a further 5 seconds, or when you tap
again, the configured standard is displayed.
2. In order to start the self-test, tap the enclosure lid
within 10 seconds.
☑ The message shown on the right appears in the
display.
3. Now activate the self-test within 20 seconds by tapping on the enclosure lid again.
☑ Once you have started the test sequence, the inverter checks the disconnection times for
overvoltage, undervoltage, maximum frequency and minimum frequency one after the other.
During the tests, the inverter shows the values in the display which are described in section
7.3.2 "Test Sequence" (page 65). When the inverter has carried out the 4 tests, it switches to
normal operation. The original calibration values are reset.
64 STP8-17TL-IA-IEN112030
SMA Solar Technology AG
Installation Manual