Table of Contents
Advertisement
Before installation
3
3.1
Safety requirements
Be sure to preview the standard operating procedures (SOP) and ensure local building and electrical codes
are reviewed before installing the EV Ultra fast charger.
The EV Ultra fast charger should be installed by a trained technician according to the instruction manual and
local safety regulations.
Use appropriate protection when connecting to the main power distribution cable.
3.2
Recommended tools
The following tools are recommended for the EV Ultra fast charger installation:
-
(1x) No.2 Philips screw driver
-
M10 hexagon screw (optional for OPI2020)
-
M10 flat washer (optional for OPI2020)
-
M10 or M12 expansion bolts
-
(1x) concrete drill
-
(1x) wire cutters
-
(1x) 17mm ratcheting wrench for the base
-
(1x) RJ45 crimping tool
-
RJ45 connectors
3.3
Important safety instructions
Save these Instructions.
The EV Ultra fast charger should be installed only by a licensed contractor, and/or a licensed
electrician in accordance with all applicable state, local and national electrical codes and
standards.
Before installing the EV Ultra fast charger, review this manual carefully and consult with a
licensed contractor, licensed electrician and trained installation expert to ensure compliance
with local building practices, climate conditions, safety standards, and state and local codes.
Warning! Danger of electrical shock or injury. Turn OFF power at the panel board or load center
before working inside the equipment or removing any component. Do not remove circuit protective
devices or any other component until the power is turned OFF.
Caution! TO AVOID DAMAGE TO THE CHARGER OR PERSONAL INJURY, MAKE SURE THE
INSTALLATION LOCATION IS ABLE TO SUPPORT THE WEIGHT OF THE ULTRA FAST
CHARGER.
4
EV Ultra Fast Charger Before installation
Advertisement
Table of Contents
