Related Manuals for Honeywell Howard Leight VERISHIELD VS 321
Summary of Contents for Honeywell Howard Leight VERISHIELD VS 321
- Page 1 VERISHIELD - VS 321 User instructions Hearing Protection Headset VS321 User instructions Mode d’emploi Instrucciones de uso ®...
- Page 2 VERISHIELD - VS 321 (A) BATTERY REPLACEMENT AND CHARGING BATTERY STATUS Battery level 100-10% 10-0% LED [C8] colour GREEN BATTERY CHARGING WITH USB CABLE Veri Shield LED [C4] Status RED (blinking) Charging in progress INSTR VS 110, VS120 & VS130 GREEN Charged, ready to use Plac...
- Page 3 (C) OPERATING THE HEADSET - HEADSET CONTROLS (D) TEST RESULTS AND TECHNICAL DATA TESTED ACCORDING TO ANSI S3.19-1974 Frequency, Hz *D1 125 250 500 1000 2000 3150 4000 6300 8000 x dB Mean Attenuation, dB *D2 Canada Standard Deviation, dB *D3 Class xx Headband Force: Small = XX N, Medium = XX N, Large = XX N *D5 TESTED ACCORDING TO AS/NZS 1270:2002...
-
Page 4: Product Description
The wearer should check correct operation before use. If failure is detected, the wearer should stop using the product and refer to Honeywell’s advice for maintenance and replacement of battery. Following features are available in the headset:... -
Page 5: Important User Information
8 This product may be adversely affected by certain chemical substances. Further information should be sought from the manufacturer. 9 All Honeywell thermoplastic hearing protection products will remain in good condition with regard to shelf life while the product is stored in a warehouse under controlled conditions. -
Page 6: Pair With Bluetooth Device
User instructions FIT TEST Double press Perform Fit test Repeated audio tone Fit test result: Good fit Positive audio tone Fit test result: Poor fit Negative audio tone CALIBRATION Calibration in progress *C3 Blinking Green Calibration Complete *C3 Solid Green MAINTENANCE Factory reset Recovery mode... -
Page 7: Audio Input Levels
ATTENUATION DATA Verishield is tested and approved in accordance with ANSI S3.19-1974 Standard at Michael & Associates Inc., USA. Verishield Attenuation Data according to American National Standards Institute Specifications ANSI S3.19-1974 (in passive mode, electronics switched off) The level of noise entering a person’s ear, when hearing protection is worn as directed, is closely approximated by the difference between the A-weighted environmental level and the NRR. - Page 10 Product is compatible with any specific third party hardware or software other than as expressly specified by Honeywell and further does not represent or warrant that any type of warning signals including communication with other people in the surroundings can be heard and understood by the wearer of this hearing protector.
- Page 11 The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Honeywell Safety Products USA, Inc. is under license. Other trademarks and trade names are those of their respective owners.
-
Page 12: Support & Contact
MANUFACTURER Honeywell Safety Products USA, Inc. 7828 Waterville Road, San Diego, CA92154 (800)430-5490 www.honeywellsafety.com SUPPORT & CONTACT UNITED STATES 7828 Waterville Road San Diego, CA 92154 USA T 1 800 430 5490 Document number: 23426-4040-181009 © All rights reserved.