Table of Contents
Advertisement
TO OPTIONAL HOOD/
TRUNK PINS OR SENSORS
REMOTE
START UNIT
module programming
The System Features Learn Routine dictates how the unit operates. Due to the number of steps, they have
been broken up into two menus. It is possible to access and change any of the feature settings using
the Override switch. However, this process can be greatly simplified by using the Pro Security
Programmer. Any of the settings can be changed and then assigned to a particular remote, up to four,
a feature called individual recognition. Each time that particular remote is used to disarm the system,
the assigned feature settings will be recalled. Individual recognition is only possible when programming
the unit via the Pro Security Programmer.
If the system was previously programmed using the Pro Security Programmer, the learn routine may be
locked. If the siren generates one long chirp when attempting to program the unit, the learn routine is
locked and must be unlocked using the Pro Security Programmer.
1.
Open a door. (The H1/5 GREEN wire or the H1/7 VIOLET wire must be con-
nected.)
2.
Ignition. Turn the ignition on, then back off: (The H1/9 YELLOW wire must be
connected.)
3.
Select a Menu. Press and HOLD the Override switch: (The Override switch must
be plugged into the blue port.) After three seconds the siren will chirp once indicating
entry to the Basic Features Menu #1. If this is the menu you wish to access, release the
button and go on to Step 4. If the button is not released, you will jump to the Advanced
Features Menu #2 and the siren will chirp twice. Once you have selected the desired
menu, release the Valet/Program button and then proceed to Step 4.
4. Select a Feature. Press and release the Override switch the number of times cor-
responding to the feature you wish to change. For example, to access the third fea-
ture, press and release the switch three times. Then press the switch once more and
HOLD it. The siren will chirp the number of times equal to the step you have accessed.
5.
Program the Feature. While holding the Override switch, you can toggle the fea-
ture on and off using the remote. Pressing
Pressing
will select the two chirp setting.
(See Module Programming section of this guide.)
BLUE WIRE H1/6
CONTROL UNIT
ZONE 1 INPUT
1N4004 DIODES
BLUE (-) STATUS
OUTPUT
will select the one chirp setting.
25
Advertisement
Table of Contents
