Table of Contents
Advertisement
12.2 Input Data Formats
12.2.1 Paper feed command for "n" lines
1st byte
D8
2nd byte
D8
When the number of lines to be fed (2nd byte) is written-in following the paper feed command (1st
byte), the paper will be fed by the number of lines specified. The number of lines to be fed can be
specified from n = 1 to 127. If "0" is specified, paper feed will not be carried out.
When there is data in the print buffer at the time this command is applied, this data will first to
printed out and then line feeding of "n" – lines will be performed.
12.2.2 Enlarged character command
D8
The data following this command, are printed out in twice the normal width.
This mode will continue until the corresponding cancel command is input, or automatically
released after printing one line. Since enlarged characters are twice the normal width, care should
be taken to avoid exceeding the column capacity.
12.2.3 Enlarged character cancel command
This command is used for canceling the enlarged character mode set by SO, and the following data
will be printed out in the normal character mode.
D8
CITIZEN
0
0
0
0
0
N7
N6
N5
(Binary digits)
0
0
0
0
0
0
0
0
D1
0
0
0
0
D1
N4
N3
N2
N1
D1
1
1
1
0
D1
1
1
1
1
29
iDP3540/3541 User's Manual
FF(0C)H
n(N7 N1)
SO(0E)H
SI(0F)H
Advertisement
Table of Contents
