Input Data Formats; Paper Feed Command For "N" Lines; Enlarged Character Command; Enlarged Character Cancel Command - Citizen iDP-3540/3541 User Manual

12-2. Input Data Formats

12-2-1. Paper feed command for "n" lines

1st byte
D8
0
2nd byte
D8
0
When the number of lines to be fed (2
st
(1 byte), the paper will be fed by the number of lines specified. The number of lines to be fed can
be specified from n = 1 to 127. If "0" is specified, paper feed will not be carried out.
When there is data in the print buffer at the time this command is applied, this data will first to
printed out and then line feeding of "n" – lines will be performed.

12-2-2. Enlarged character command

D8
0
The data following this command, are printed out in twice the normal width.
This mode will continue until the corresponding cancel command is input, or automatically
released after printing one line. Since enlarged characters are twice the normal width, care should
be taken to avoid exceeding the column capacity.

12-2-3. Enlarged character cancel command

This command is used for canceling the enlarged character mode set by SO, and the following data
will be printed out in the normal character mode.
D8
0
CITIZEN
0 0 0 0
N7 N6 N5 N4
(Binary digits)
nd
byte) is written-in following the paper feed command
0 0 0 1
0 0 0 1
34/48
iDP-3540/41 User's Manual
D1
0 0 0
FF(0C)H
D1
N3 N2 N1
n(N7 N1)
D1
1 1 0
SO(0E)H
D1
1 1 1
SI(0F)H