Tear-Off And Type Of Data; Cut Position Adjustments - Citizen CLP-6001 User Manual

All manuals and user guides at all-guides.com

6.5.4 Tear-off and type of data

When the tear-off is valid, the printer monitors the print data for 0.5 second
during or after printing. If print data is transm itted within 0.5 second during or
after printing, the printer will start next printing without tear-off.
received during printing, the time of monitoring 0.5 second is not inserted.)
The commands for this printer are mainly classified into the immediately
execution commands starting with "SOH" and the sequentially execution
commands starting with "STX."
sequentially execution commands related to print processing contents are
monitored but the immediately execution commands are not monitored.
Therefore, even if the printer status or the remaining number of print sheets
is read out by using the immediately execution commands during printing,
the tear-off will be performed after printing.
sequentially execution commands are used during printing or within 0.5
second after printing to transmit print-related data, the printer will start next
printing without tear-off.

6.5.5 Cut position adjustments

•
The cut position can be set with the "fnnn" of the system-level
commands.
initialization value is set in the printer.
Initialization value:
The values higher or lower will increase or decrease the amount of feed
in the tear-off.
Tear bar
Tear off
In the tear-off function, only the
(For details, see the Command Reference.)
When the tear-off function is turned on, the following
fnnn = f733 (73.3 mm)
Paper position sensor
Print head
Onnnn
fnnn
6-17
(When data is
On the other hand, if the
Onnnn: Paper position setting
fnnn: Feed position setting
fnnn <= Onnnn
Feed or back-feed is not
performed
fnnn > Onnnn
Feed or back-feed is
performed