Advertisement
3
Power On
Dig the groove to disassemble the device. Remove the front and rear panel. Turn the power switch to ON to power on the device.
Note: Do not disassemble the device with sharps.
4
Enrollment
1. Log in to the APP Store, download and install the App.
2. Power on the security control panel.
3. Log in the APP and tap the icon "+" . Scan the QR code or input the control panel serial No. to add the control panel.
Enroll the Peripheral Locally
1
1. In the APP, tap the "Enrollment Mode" button on the control panel page to make the control
panel enter the enrollment status.
2. Power on the peripheral, and it will be automatically enrolled to the control panel.
Enroll the Peripheral with QR and serial No.
2
1. In the APP, tap the icon "+"and scan the QR code or serial No. on the peripheral.
2. Power on the peripheral, and it will be automatically enrolled to the control panel.
5
Test
The contact starts test automatically after being enrolled to the AX PRO. The LED turn red.
Separate the contact, and make a gap between the sensor and stick. while the LED turns green, the alarm is triggered by this gap . Adjust the installation
position of the contact to get a satisfied alarm gap.
The alarm will be triggered while the gap between the sensor and magnetic stick is bigger than that shows in the table. The LED keeps blue for 2 s.
Magnet Detection Performance Table
xxxx
Device
Axes of
Event
Operation
Break
X+
Make
Break
X-
Make
Break
Y
Make
Break
Z+
Make
Break
Z-
Make
Hangzhou Hikvision Digital Technology CO.,Ltd. No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
On non-ferromagnetic
On ferromagnetic
material surface
material surface
11
10
11
10
28
24
31
27
45
42
2
CAUTION
IF THE BATTERY COMPARTMENT
DOES NOT CLOSE SECURELY,
STOP USING THE PRODUCT AND
KEEP IT AWAY FROM CHILDREN.
10
8
10
9
15
12
22
20
15
13
Advertisement
