Wps - HMS Networks Airconwithme Device Configuration

3.5

WPS

There are 2 ways to start the WPS configuration procedure
1. Tap on WPS (See
2. Press one time the button to activate the WPS. Further information can be found at
Section 2.2
Follow the instructions in the screen shown (See
the light of the LED will blink blue, 2 minutes after the WPS button of the router had been
pressed the light of the LED will be off (See
© HMS Industrial Networks S.L.U - All rights reserved
This information is subject to change without notice
Figure 3.14).
Figure 3.14 WPS configuration procedure.
Figure 3.15 Instructions to perform WPS mode configuration.
Figure 3.15). Tap on Next.
Figure 3.16).
Device Configuration 1.0
URL https://airconwithme.com
16 / 20