Installing The Sfps; Powering Up The Switch - Cisco MDS 9148 Quick Start Manual

Send documentation comments to mdsfeedback-doc@cisco.com
4

Installing the SFPs

Install one of the following SFPs in each empty port:
• A Fibre Channel Shortwave 1-, 2-, 4-, or 8-Gbps SFP transceiver, part number DS-SFP-FC8G-SW
• A Fibre Channel Long wavelength 1-, 2-, 4-, or 8-Gbps SFP transceiver, part number DS-SFP-FC8G-LW
• A Fibre Channel Short wavelength 1-, 2-, or 4-Gbps SFP transceiver, part number DS-SFP-FC4G-SW
For SFP installation, see Figure
Figure 4 SFP Installation
5

Powering Up the Switch

To power up the switch, follow these steps:
Step 1 Ground the switch, as shown in
4
4.
Figure 5.