Cisco ASR1002 Installation Manual page 31

Chapter 8 Cisco ASR 1002 Router Overview and Installation
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Warning
Statement 1003
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Never install an AC power module and a DC power module in the same chassis. Statement 1050
Warning
Warning Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning When installing or replacing the unit, the ground connection must always be made first and
disconnected last. Statement 1046
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
Warning
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
This unit has two power supply connections. All connections must be removed to de-energize the unit.
Warning
Statement 1028
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
Warning
the protective device is rated not greater than: AC power supplies 20 A and DC power supplies 30 A.
Statement 1005
This section provides the procedures for connecting AC-input, –48 VDC input power, and the +24 VDC
input power to your Cisco ASR 1002 Router.
Detailed instructions for removing and replacing the Cisco ASR 1002 Router AC and DC power supplies
Note
are in
Connecting AC Input Power to Cisco ASR 1002 Router
To connect AC power to the Cisco ASR 1002 Router, follow these steps:
At the rear of the router, check that the power switch is in the Off (O) position.
Step 1
Note
OL-13208-09
Chapter 13, "Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers."
Turn the power switch to the On (|) position after both sides of the power cord are connected.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
Cisco ASR 1002 Router Power Supplies
8-31