Adjusting The Shift Pedal - Yamaha YFZ450S 2003 Service Manual

BLEEDING THE HYDRAULIC BRAKE SYSTEM/
a
2

ADJUSTING THE SHIFT PEDAL

i. Repeat steps (e) to (h) until all of the air
j. Tighten the bleed screw to specification.
k. Fill the brake fluid reservoir to the proper
_
After bleeding the hydraulic brake system,
check the brake operation.
L
EBS00098
ADJUSTING THE SHIFT PEDAL
1. Measure:
2. Adjust:
M
a. Loosen the bolt 1.
b. Remove the shift pedal 2.
c. Install the shift pedal at the correct height.
1
d. Tighten the bolt to specification.
L
3 - 41
bubbles have disappeared from the brake
fluid in the plastic hose.
Bleed screw
6 Nm (0.6 m · kg, 4.3 ft · lb)
level with the recommended brake fluid.
Refer to "CHECKING THE BRAKE FLUID
LEVEL".
WARNING
LLL L LLL L L LLL L L LLL
• shift pedal height a
Out of specification → Adjust.
Shift pedal height
25 mm (0.98 in)
• shift pedal position
MMM M MMM M M MMM M M MMM
12 Nm (1.2 m · kg, 8.7 ft · lb)
LLL L LLL L L LLL L L LLL
CHK
ADJ
L L LLL L L LLL L
M M MMM M M MMM M
L L LLL L L LLL L
LLL
MMM
LLL