Adjusting The Rear Brake; Adjusting The Parking Brake - Yamaha YFZ450S 2003 Service Manual

ADJUSTING THE PARKING BRAKE

a
2
1
a

ADJUSTING THE REAR BRAKE/

3 - 34
2. Adjust:
• rear brake pedal height
M MMM M MMM M M MMM M
a. Loosen the locknut 1.
b. Turn the adjusting bolt 2 until the brake
pedal height is within the specified limits.
c. Tighten the locknut.
NOTE:
_
When adjusting the brake pedal height make
sure the locknut-to-adjusting bolt clearance a
does not exceed 2.2 ~ 3.2 mm (0.09 ~ 0.13 in).
WARNING
_
After this adjustment is performed, lift the
front and rear wheels off the ground by
placing a block under the engine, and spin
the rear wheels to ensure there is no brake
drag. If any brake drag is noticed, perform
the above steps again.
L LLL L LLL L L LLL L
ADJUSTING THE PARKING BRAKE
1. Check:
• parking brake cable end length a
Out of specification → Adjust.
Parking brake cable end length
56 ~ 60 mm (2.20 ~ 2.36 in)
CHK
ADJ
M MMM M M MMM M M MMM M
L LLL L L LLL L L LLL L
MMM
LLL