Advertisement
COMPARI ON VOLTAGE Helidial.
dial reading should not be further than ½ minor division
(which is 5 millivolts) from the 10.000 position.
At null, the Helidial
and insert the Z Unit directly into the oscilloscope plug-in
compartment. Install the left side panel on the oscilloscope.
Disconnect the voltmeter, remove the plug-in extension
Calibration — Type Z
5-7
Advertisement
Related Manuals for Tektronix Type Z
Related Products for Tektronix Type Z
- Tektronix TYPE Z PLIG-IN
- Tektronix Z840/DP - Phaser 840 Plus Color Solid Ink Printer
- Tektronix Z240 - Phaser 240 Color Thermal Transfer Printer
- Tektronix Z840/DX - Phaser 840 Color Solid Ink Printer
- Tektronix Z350/X - Phaser 350 Color Solid Ink Printer
- Tektronix Z740U/DP - Phaser 740 Duplex Color Laser Printer
- Tektronix Z750/N - Phaser Color Laser Printer
- Tektronix Z740/DX - Phaser 740 Extended Color Laser Printer
- Tektronix Z740/N - Phaser 740 Color Laser Printer
- Tektronix Z740/P - Phaser 740 Plus Color Laser Printer
- Tektronix Z750/P - Phaser Color Laser Printer
- Tektronix Z780N - Phaser 780 Color Laser Printer
- Tektronix Z780/P - Phaser 780 Plus Color Laser Printer
- Tektronix Z780GN - Phaser 780 Graphics Color Laser Printer
- Tektronix Z-Active Series
- Tektronix 070-5615-03
Need help?
Do you have a question about the Type Z and is the answer not in the manual?