Steps
1. Place the power-button with fingerprint reader into the slot on the palm-rest assembly.
2. Replace the screw (M2x3) that secures the power-button with fingerprint reader to the palm-rest assembly.
3. Adhere the tape that secures the power-button with fingerprint reader cable to the palm-rest assembly.
4. Connect the power-button with fingerprint-reader cable to the power-button board and close the latch.
5. Adhere the tape that secures the power-button with fingerprint reader cable to the palm-rest assembly.
6. Place the power-button bracket on the power-button with fingerprint reader.
7. Replace the screw (M2x3) that secures the power-button bracket to the palm-rest assembly.
Next steps
1. Install the
I/O
board.
2. Install the fan.
3. Install the
base
cover.
4. Follow the procedure in
System board
Removing the system board
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
M.2 2230 solid-state
4. Remove the
M.2 2280 solid-state drive/Intel Optane
5. Remove the battery.
6. Remove the fan.
7. Remove the
heat
sink.
After working inside your
Before working inside your
drive. (if applicable)
computer.
computer.
H10. (if applicable)
Removing and installing components
41