Steps
1. Using the alignment posts, place the right speaker on the palm-rest assembly.
NOTE:
Ensure that the alignment posts are threaded through the rubber grommets on the speaker.
2. Route the speaker cable through the routing guides on the palm-rest assembly.
3. Using the alignment posts, place the left speaker on the palm-rest assembly.
NOTE:
Ensure that the alignment posts are threaded through the rubber grommets on the speaker.
4. Route the speaker cable through the routing guides on the fan.
5. Connect the speaker cable to the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Heat sink
Removing the heat sink
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
NOTE:
The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you
touch it.
NOTE:
For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The oils in your skin
can reduce the heat transfer capability of the thermal grease.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
37