Installing The Touchpad - Dell Inspiron 7306 2-in-1 Silver Service Manual

Steps
1. Remove the three screws (M1.6x2) that secure the touchpad bracket to the palm-rest assembly.
2. Peel the mylar that covers the tape that secures the touchpad to the palm-rest assembly.
3. Lift the touchpad bracket off the palm-rest assembly.
4. Open the latch and disconnect the touchpad cable from the system board.
5. Remove the two screws (M2x2) that secure the touchpad to the palm-rest assembly.
6. Peel the tapes that secure the touchpad to the palm-rest assembly.
7. Lift the touchpad from the palm-rest assembly.

Installing the touchpad

Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the touchpad and provides a visual representation of the installation procedure.
34 Removing and installing components