Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for anko Folding Bed Rail
Summary of Contents for anko Folding Bed Rail
- Page 1 Folding Bed Rail IMPORTANT! KEEP FOR FUTURE REFERENCE - READ CAREFULLY.
-
Page 2: Safety Information
SAFETY INFORMATION READ THIS INSTRUCTION MANUAL CAREFULLY AND KEEP IT IN A SAFE PLACE FOR FUTURE REFERENCE. THE CORRECT USE AND MAINTENANCE OF THIS PRODUCT IS ESSENTIAL. WARNING • Adult assembly required. • Read all the instructions before assembly and use of the product. •... -
Page 3: Parts List
PARTS LIST A. Bed rail mesh wall B. Right upper support bar C. Left upper support bar D. Right bottom support bar E. Left bottom support bar F. Right under bar G. Left under bar H. Strap... -
Page 4: Installation
INSTALLATION Step 1: Insert upper support bar (left and right) into bottom support bar (left and right). Make sure the spring pin fits securely into opposing hole so that the two pieces cannot pull apart. Step 2: With the left and right sides of the bed rail assembled, connect the two sides. Make sure the spring pin fits securely into opposing hole so that the bed rail cannot pull apart. - Page 5 Step 3: To install the mesh wall on the bed rail, slide the mesh wall over the frame until it reaches the other end and zip it shut to complete the installation. Step 4: Connect the under bars with the straps with the assembled panel as per Step 3. Insert the plastic hinge into the assembled panel and press in the metal spring button to fully insert the tube into the hole in the plastic hinge.
- Page 6 Unlocked position Locked position Step 5: Locking mechanism. POSITIONING THE BED RAIL slider Step 1: Set up the bed rail in locked position. Place the bed rail on the side of the bed that you would like to have protected, place the fixed plate with strap on the opposite side of the bed rail and mount to the outer edge of the box spring.
- Page 7 Step 2: Check to make sure the left and right under bar assemblies are parallel to one another, then place the mattress on the top of the assembly. WARNING: To prevent the risk of strangulation, it is essential to ensure that when the bed rail is fitted into position, there is a gap of at least 250mm (10in), between each end of the bed and the corresponding end of the bed rail.
- Page 8 USING THE BED RAIL unlock position lock position up position down position Step up bed rail: Swing up the panel. Turn the locking tabs and hold them at unlocked position. Continue to swing until the panel touches the side of the mattress. Release the locking tabs and the bed rail is locked into use position.
- Page 9 Keycode : 42399438 MADE IN CHINA ©KMART AUSTRALIA LIMITED ANKO, KIDS&CO. & BABY SOLUTIONS® ARE TRADEMARKS OF KMART AUSTRALIA LIMITED. THEY ARE USED IN NEW ZEALAND BY KMART NZ HOLDINGS LIMITED TRADING AS KMART IN NEW ZEALAND. KMART AUSTRALIA - 690 SPRINGVALE RD, MULGRAVE, VIC 3170 AUSTRALIA.
Need help?
Do you have a question about the Folding Bed Rail and is the answer not in the manual?
Questions and answers