Assembly - Hanging the fan (continued)
4
Hanging the fan
WARNING: The hook is only to balance the fan while attaching
wiring. Failure to hang the fan according to these instructions
may result in the hook breaking, causing the fan to fall. The
hook must pass from the inside to the outside of the canopy.
□
Carefully lift the fan motor assembly (D) up to the mounting
bracket (A).
□
Seat the hanger ball portion of the ball/downrod assembly (B)
in the mounting bracket (A) socket. Ensure that the tab on the
mounting bracket (A) socket is properly seated in the groove
in the hanger ball.
□
If using close-to-ceiling mounting, hang the fan motor assembly
(D) on the hook provided by utilizing one of the holes at the outer
rim of the ceiling canopy (C).
5
Wrapping the extra wire
□
Gently wrap the excess wire around the mounting bracket,
under the receiver.
□
Secure with electrical tape.
A
C
D
A
B
C
D
9
NOTE: Follow this step ONLY if you did not cut the extra length off
from the wires coming from the ceiling fan to the receiver.
Please contact 1-855-HD-HAMPTON for further assistance.
HAMPTONBAY.COM