Operation - HAMPTON BAY PORTSMOUTH 51355 Use And Care Manual

Assembly - Attaching the Light Kit (continued)
11
Installing the bulbs and glass shade
□
With the power off, install two bulbs (J) (Max. 9.5W,
included) by twisting them into the light bulb sockets.
□
Place the glass shade (I) into the light kit fitter assembly (E),
aligning the three flat areas on the top flange of the glass
shade (I) with the three raised dimples in the light kit fitter
assembly (E). Then turn the glass shade (I) clockwise until it
stops.
□
Attach the pull chain fobs (FF) to the pull chains exiting the
pull chain guide.
NOTE: Periodically check that the glass shade is seated fully
clockwise in the light kit assembly.
NOTE: Notice the location of the fan's slide switch. This is the
switch used to change the fan's directional rotation. For more
information on the operation of this switch, see "Slide Switch
Operation Instructions" on page 12.

Operation

NOTE: Wait for the fan to stop before reversing the direction of
blade rotation.
PULL CHAIN OPERATING INSTRUCTIONS
Turn on the power and check the operation of the fan. The pull
chain controls the fan speeds as follows:
1 pull - High, 2 pulls - Medium, 3 pulls - Low, 4 pulls - off
The appropriate speed settings for warm or cool weather depends
on factors such as the room size, ceiling height, and number of
fans.
REVERSE SWITCH OPERATING
INSTRUCTIONS
The slide switch controls the direction of the blades: forward (switch
down) or reverse (switch up).
Warm weather - (Forward) A downward airflow creates a cooling
effect. This allows you to set your air conditioner on a warmer
setting without affecting your comfort.
Cool weather - (Reverse) An upward airflow moves warm air off
of the ceiling. This allows you to set your heating unit on a cooler
setting without affecting your comfort.
J
12
E
FF
I