HAMPTON BAY PORTSMOUTH 51355 Use And Care Manual page 8

Assembly - Close-To-Ceiling Mount
1
Preparing for close-to-ceiling
mounting
□
Remove the canopy ring (JJ) from the canopy (C) by turning the
ring counter-clockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (HH) located in the "L shaped
slots".
□
Remove and save the two canopy screws (II) in the round holes.
This will enable you to remove the mounting bracket (A).
□
Remove the decorative canopy bottom cover (L) from the
canopy (C) by depressing the three studs.
HH
Assembly - Hanging the fan
3
Attaching the fan to the electrical
box
WARNING: To reduce the risk of fire, electric shock or personal
injury, mount to outlet box marked "acceptable for fan support
of 35lbs. (15.9 Kg) or less" and use screws provided with the
outlet box.
□
Pass the 120-Volt supply wires through the center hole in the
mounting bracket (A).
□
Attach the mounting bracket (A) to the outlet box by sliding the
mounting bracket (A) over the two screws provided with the outlet
box. If necessary, use leveling washers (not included) between
the mounting bracket (A) and the outlet box. Note that the flat
side of the mounting bracket (A) is toward the outlet box.
□
Securely tighten the two mounting screws.
2
Routing the wires
□
Remove three of the six screws and lockwashers (LL) (every
other one) securing the motor collar (M) to the top of the fan
motor assembly (D).
□
Place the rubber gasket (EE) over the remaining three
screws, route the wires exiting the top of the fan motor
assembly (D) through the canopy ring (JJ) (make sure the
slot opening is on top), then proceed to place the ceiling
canopy (C) over the motor collar (M) at the top of the fan
motor assembly (D).
□
Align the mounting holes with the holes in the fan motor
assembly (D), and fasten using the three screws and
lockwashers (LL) removed previously. Tighten the mounting
screws securely.
A
II
C
L
JJ
8
LL
C
EE
M
D
B
A