Advertisement
Table of Contents
This instruction manual is related to installation, wiring using and maintenance of Contactor/Starter.
Before using this Contactor/Starter, you should first throughly read this manual, in order to
understand appropriate usage and handling.
Don't touch electric connecting terminal, or you should be damaged by electric-shock.
●
Check the wire is anenergized at the time of maintenance, or you should be damaged by electric-
●
shock.
Make sure of clearance written by this manual at the time of installation, or you should be damaged
●
by electric-shock.
Tighten screws by appropriate tightening torque, or there is in danger of fire.
●
1．Before installation
Before installation, be sure whether Type, Rating current, Coil voltage, Frequency marked on the
name plate are agreed with ordered specifications and whether there are no fallen off parts or any
damaged portions.
2．Installation
At the time of installation, secure appropriate space shown by this manual.
The Contactor / Starter must be secured on an upright panel or wall arranged to prevent from
excessive dust, oil-mist and vibration so that the line end of contactor becomes top.
3．Wiring
Wiring must be used appropriate size of electric wire, and tighten appropriate tightening torque
shown by this manual.
Frame
H series
HS series
XS4
8～50
65C
80C～150C
200C,250C
300C,400C
600C,800C
Note : ※ is allowed for 0.
MAGNETIC
CONTACTOR/STARTER
Instruction Manual
Introduction
Notes of Safety
！
！ CAUTION
Table1 clearances at installation
Clearance (minimum : mm)
A
B
RH series
5
10
5
15
25N, 50N
※ 1
15
60N, 120N
※ 1
15
200N
※ 1
25
※ 1
30
※ 1
50
In case of separate mounting for Thermal Relay...A:10 B:15 C:5 D:15 E:5
DANGER
C
D
E
0
10
0
Metal or ground
5
10
5
5
10
5
D
10
10
10
Metal or ground
10
10
10
10
10
10
D
10
10
10
Send to end-user this
instruction manual
certainly.
(S-11-017-C)
Mounting space
Metal or ground
C
insulator
E
A
Magnetic
Contactor
Metal or ground
C
insulator
A
E
Magnetic
Starter
⑰
B
dimension
of switch
B
dimension
of switch
Advertisement
Table of Contents
Related Manuals for Hitachi H Series
Summary of Contents for Hitachi H Series
- Page 1 Wiring must be used appropriate size of electric wire, and tighten appropriate tightening torque shown by this manual. Table1 clearances at installation Frame Clearance (minimum : mm) Mounting space RH series H series HS series Metal or ground Metal or ground 8～50 insulator 25N, 50N ※...
- Page 2 Table2 Wire size and tightening torque Frame(Contactor) Thermal Relay max. width Appropriate screw max. wire of solderless tightening size size (mm terminal torque H series HS series RH series 1E, 2E (mm) (N･m) M3.5 2(φ1.6) 0.8～1.0 XS4, 8, 10 3.5(φ2) 1.2～1.5 3.5(φ2) 10.5...
Need help?
Do you have a question about the H Series and is the answer not in the manual?
Questions and answers