Maintenance And Upkeep; Maintenance - Hobby BEACHY 2022 Operation Manual

Table of Contents

Advertisement

11. Maintenance and upkeep

11.1 Maintenance

Bearing surfaces on the casing of the overrun
coupling
Maintenance intervals
fixed maintenance intervals apply to the caravan and the devices
installed in it.
Rules for maintenance intervals
• The 1st annual maintenance check should be carried out by an
authorised HOBBY dealer no later than 12 months after the initi-
al registration date.
• Have all further maintenance performed once annually at a
HOBBY dealer.
• Have all maintenance on built-in devices performed in accor-
dance with the corresponding maintenance intervals indicated in
the operating instructions.
Greasing and oiling
Regularly examine and grease the sliding parts and stationary parts
of the chassis. If the caravan is used seldom, yearly maintenance is
required.
Rules for greasing and oiling
1
• Movable parts such as pins and hinged parts on the hand brake
lever and deflexion lever of the ramp should be oiled lightly.
• Lightly grease the stationary parts on the case of the overrunning
equipment
• Check from time to time to ensure that the bearing surfaces of the
brake rod are not jammed.
• Clean and oil all movable and stationary parts regularly.
Hobby's voluntarily granted (5 year) warranty against
leaks in the mobile home, as set out in the guarantee
conditions, will only take effect if the (chargeable) in-
spections for leaks were carried out correctly. To this
end, the mobile home must be taken to a Hobby dealer
12-18 months after receipt of the vehicle. After the initial
inspection for leaks, this inspection must be repeated
every 12 months during the warranty period.
Hobby recommends that you contact a service partner
before driving there and enquire whether they have the
necessary capacity (e.g. an adequate car lift) in order to
avoid any misunderstanding.
j
after every 5,000 kilometres of driving.
For safety reasons, the spare parts for heating devices
must conform with the manufacturer's instructions.
They must be installed by the manufacturer or an autho-
rised representative.
IMPORTANT: The friction pads of the KS 25 stabiliser
hitch must never be lubricated with either oil or grease.
56

Advertisement

Table of Contents
loading

Table of Contents