Table of Contents
Advertisement
RXi2-BP Hardware Reference Manual
GFK-3187B
4.2.1
Power Supply
WARNING
Verify that the power supply is turned off while installing boards or modules into the RXi2-BP IPC.
Adhere to the following guidelines:
•
•
4.2.2
Keyboard
A compatible USB keyboard for the initial system operation of the RXi2-BP IPC is required.
Depending on your application, this may be a standard keyboard or one that uses membrane
switches for harsh environments.
4.2.3
Video Monitor
Any video monitor with a native Display Port (or a suitable adaptor for the Display Port) can be used
for the initial setup.
4.3
Minimum System Requirements
The RXi2-BP IPC has been thoroughly tested and is nearly ready for usage in the target system. To
verify operation for the first time, Emerson recommends that you only configure a minimal system.
It is not necessary to have disk drives, a flash disk, or other accessories connected, to perform the
Power-On Self-Test (POST).
4.4
Initial Startup
A few seconds after powering up, the RXi2-BP IPC system UEFI Firmware banner will display on the
screen. If you do not see any error messages up to this point, the RXi2-BP IPC is running properly
and ready to be configured for your application.
Note:
Installation and Setup
Verify that the power supply can meet the total power requirements of the RXi2-BP IPC.
(Refer to the section Specifications.)
Verify that the power supply is not turned ON while opening the enclosure to install add-
on boards and modules into the RXi2-BP IPC (such as the PCIe boards or internal SATA
drives).
If the RXi2-BP IPC does not perform as described above, some damage may have occurred during
shipment, or the board is not installed or configured properly. Contact Emerson for technical support.
(Refer to the section Contact Information.)
Section 4
November 2020
12
Advertisement
Table of Contents
