Menu' 12 Enable Blower (If Available); Fuel Loading; Appliance Starting - L'Artistico GERICO 9 Instructions For Use Manual

17. MENU' 12 ENABLE BLOWER (if available)

This menu item (if available) can be enabled (ON) or disable (OFF) the air blower.
If the fan is disabled (OFF), the appliance can only operate at power 1 or 2 or 3 max (it is not possible to set
power 4 or 5) to avoid overheating of the appliance and any damage.
Attention: Only models B6 - B9 - B10 (sealed chamber) and some pellet fireplaces allow the fan to be deactivated
(OFF). In other models, this menu is not present and therefore cannot be used.
°
To modify

18. FUEL LOADING

In the models of stoves with sealed chamber (type B ...) if the unit is on, by opening the lid of the pellet feed
tank, you have 180" time max for charging. After this period, the device will give the
alarm and the device will automatically shutdown.
WARNING: the pellet loading door must remain closed while the appliance is operating. Using the appliance with the
door open is prohibited as it alters all combustion values.
Do not overfill the tank with the risk of spilling the pellets.
It is forbidden to leave pellets on the hot parts of the appliance, especially on the top cover, it could catch fire. In case
of accidental leaking from the pellet tank, it must be strictly removed and vacuumed because the dust can circulate
and create dust in the environment.
During loading, make sure that the plastic / paper bag does not come into contact with hot areas of the appliance.
However, it is highly recommended not to load directly from the bag but to use a scoop (scoop), making sure there are
no foreign bodies in the bag.
To ensure trouble-free combustion, the pellets must be stored in a dry place. The use of poor quality pellets or any
other material damages the functions of your appliance and may result in the termination of the warranty and the
associated liability of the manufacturer.
Do not allow the accumulation of sawdust on the bottom of the tank, monthly vacuum the sawdust deposited inside
the main tank.
During operation, if you notice that the pellet tank is empty, DO NOT LOAD PELLETS INTO THE TANK with the appliance switched on.
Switch off the appliance with the ON / OFF button and only after finishing the final cleaning and the chimney has turned OFF, you can reload the
pellets in the tank paying close attention to the hot parts (if necessary use an oven glove to avoid burns). ATTENTION: it is mandatory to always
clean the brazier and the combustion chamber before re-igniting the appliance. If the procedure described is not carried out, pellets may accumulate
in the brazier with the flame out with the consequent risk of gas generation and possible internal deflagration..

19. APPLIANCE STARTING

Before switching on your appliance, you must comply with the procedure and warnings described in the
installation, use and maintenance instruction booklet supplied with the appliance, in the LIGHTING AND USE
chapter; non-compliance determines the termination of the warranty and the attached liability of the
manufacturer.
Never turn on the appliance without first carrying out the inspection and daily cleaning as described in the
maintenance chapter of this manual.
The brazier must be completely clean and empty before each ignition / re-ignition, whether the latter is done
manually, or in the case of programmed ignitions with a chronothermostat, via the stand-by function or
remotely via the App (danger of explosion).
To turn on the device, hold down the ON / OFF button for about three seconds; the fireplace follows various phases during ignition:
:
L'ARTISTICO SRL |
Until to....
30
DOOR PELLET OPEN
Cod. 40297 | Rev. 09 | 05/2021 |
EN